Nokia Mobile
Phone Unlock & Hidden Feature codes
These codes will work on
most Nokia Mobile Phones to activate/deactivate advanced hidden functions
that you can’t change through the phone menu
One useful function that
all Nokia’s I’ve owned have is “Cell Info Display” which can usually be
found in the phones “Display settings” (eg: in a Nokia 1600) or “Phone
Settings” (eg: in a Nokia 3315)
If your network supports
it, when “Cell Info Display” is enabled, it will display the name of the
base station your mobile is currently connected to on the screen eg: when
i’m walking around the city it says “Sydney CBD” and when i’m at home it
displays the name of my suburb.
Note:
To display “p” press “*”
three times within one second, To display “w” press “*” four times within
one second, To display “+” press twice “*” within less than a second
Code Function
*3370# / #3370# Activate
/ Deactivate Enhanced Full Rate Codec (EFR) - Your phone uses the best
sound quality but talk time is reduced my approx. 5%
*#4720# / *#4720# Activate
/ Deactivate Half Rate Codec - Your phone uses a lower quality sound but
you should gain approx 30% more Talk Time
*#7220# / *#7230# Enable
/ Disable PCCCPH support (faster GPRS)
#pw+1234567890+1# Provider
Lock Status. (use the “*” button to obtain the “p,w” and “+” symbols)
#pw+1234567890+2# Network
Lock Status. (use the “*” button to obtain the “p,w” and “+” symbols)
#pw+1234567890+3# Country
Lock Status. (use the “*” button to obtain the “p,w” and “+” symbols)
#pw+1234567890+4# SIM Card
Lock Status. (use the “*” button to obtain the “p,w” and “+” symbols)
12345 This is the default
security code
*#0000# Displays your phones
software version, 1st Line : Software Version, 2nd Line : Software Release
Date, 3rd Line : Compression Type
*#9999# Phones software
version if *#0000# does not work
*#06# For checking the International
Mobile Equipment Identity (IMEI Number)
*#67705646# Removes operator
logo on 3310 & 3330
*#73# Reset phone timers
and game scores
*#746025625# Displays the
SIM Clock status, if your phone supports this power saving feature “SIM
Clock Stop Allowed”, it means you will get the best standby time possible
press and hold # Lets you
switch between lines
*#7760# Manufacturers code
*#7780# Restore factory
settings
*#8110# Software version
for the nokia 8110
*#92702689# Displays - 1.Serial
Number, 2.Date Made, 3.Purchase Date, 4.Date of last repair (0000 for no
repairs), 5.Transfer User Data. To exit this mode you need to switch your
phone off then on again
Instructions to Network Unlock
Your Mobile
Once you have bought or
found a network unlock code for your phone, this Network unlocking guide
will give you step by step instructions to enter it into your:
Nokia 1100/2100/3100/3120/3200/3220/3315/6610i
Sony Ericcson A2618/T230/T610/T630/Z200/
Motorola T180/T190/T300/V171/V220
Panasonic GD35, Philips
Savvy, Siemens A35/55/65, LG C1100
Nokia Error Messages
Code error – appears if
the unlock password entered is incorrect. You need to go through the whole
process again, ensuring you enter the correct 10-digit code.
Nokia Codes Tips and Tricks
- To check the IMEI (International Mobile Equipment Identity) Type-
*#06# -
Information you get from
the IMEI-
XXXXXX XX XXXXXX
X
TAC
FAC SNR SP
TAC = Type approval code
FAC = Final assembly code
SNR = Serial number
SP = Spare
To check the phones Software
revision type-
*#0000#
Information you get from
the Software revision-
V 05.31
18-02-99
NSE-3
1ST Line = Software
revision
2ND Line = The date of the
software release
3RD Line = Phone type
To enter the service menu
type-
*#92702689# (*#WAR0ANTY#)
Serial number (IMEI)
Production date (MM/YY)
Purchase date (MM/YY) You
can only enter the date once.
Date of last repair (0000=No
repair)
Transfer user data to another
Nokia phone via Infra-Red
Clock Stopping
To check weather your SIM
Card supports clock stopping type-
*#746025625# (*#SIM0CLOCK#)
Revealing the Headphone and
Car-Kit menus
Please note that if you
do these next tricks, the new menus can't be erased without retoring the
factory default settings. To do these tricks you need to short-circuit
the pins on the bottom of the phone next to where you plug in you charger.
1. To activate the "Headset"
menu, you need to short-circuit pins "3" and "4". After a short time the
word "Headset" will be shown in the display. Menu 3-6 is now enabled.
2. To activate the "Car"
menu, you need to short-circuit pins "4" and "5". After a short time the
word "Car" will be shown in the display. Menu 3-7 is now enabled.
THE REBOOT TRICK
This should work on all
software versions of the 6110.
1. Go to the Calendar (Menu-8)
2. Make a note or reminder.
3. Enter some text into
the edit box.
4. Hold "Clear" until the
whole text is cleared, then press "Back".
5. Press "0". The main screen
will now be showing but a space appears on the screen. (you can't see it)
6. Enter 4 digits (e.g.
1234).
7. Use the down arrow to
move the cursor to the left side of the numbers and the space (Down arrow
twice).
8. Now enter 6 digits and
press the call button.
Wait for a few seconds,
the screen should start to flash and reboots. It should alsowork on other
menus like the "Profiles" menu.
EFR CALL QUALITY
To activate EFR (Enhanced
Full Rate) Enter the code- *3370#
This improves call quality
but decreases batterylife by about 5%
To deactivate it, Enter the
code- #3370#
THE JAMES BOND TRICK
If you short-circuit theleft
middle and right pins on the bottom of the phone with all connections touching
each other, the Nokia software hangs! The profile "Headset" will be activated.
Before you do this just activate the "Automatic Answer" in the headset
profile and set the ringing volume to "Mute". Now you can use your phone
for checking out what people are talking about in a room. Just place it
under a table in a room and call it. The phone receives the call without
ringing and you can listen to what people are saying.
NETWORK MONITOR
There is a hidden menu inside
your Nokia phone. If you want to activate it, you'll have to re-program
some chips inside of your phone.
Check your software version.
You can only continue if you have v4.33, v4.73 or v5.24.
Take apart the phone.
De-solder the EEPROM (ATMEL
AT 24C64).
Read out the data with an
EEPROM programmer and save it to a file (Backup).
If you have v.33 or v4.73,
change the address "03B8" from "00" to "FF".
If you have v5.24 then change
the address "0378" from "00" to "FF".
Write the new data to the
EEPROM and solder it back to the phone,
Power on your phone and
you should have "Netmonitor" enabled.
The Network Monitor gives
you the following information.
Carrier number
MS RX Level in DBM
Received signal quality
MS TX power level
C1 (Path loss criterion,
used for cell selection and reselection). The range is -99 to 99.
RTL (Radio link timeout).
Timeslot
Indication of the transmitter
status
Information on the Network
parameters.
TMSI (Temporary Mobile Subscriber
Identity).
Cell identification (Cell
ID, Number of cells being used).
MCC (Mobile country code)
MCN (Mobile network code)
LAC (Location area code)
Ciphering (On/Off)
Hopping (On/Off)
DTX (On/Off)
Discard cell barred information
CHECK SIM-LOCK
Note - If you bought your
Nokia on UK Vodafone or UK Cellnet you do not need to check this because
they both transmit on GSM900, and they don't lock the phones. However if
you bought your phone on UK Orange or UK One2one your phone may be blocked.
The reason is that they both transmitt on GSM1800. To make a call on GSM1800
you need what is known as a "Dual band" phone. A dual band phone is able
to transmit on both GSM900 and GSM1800, so they lock the phones so you
can't use it with any other network simcard. If you find that your phone
is locked you can try different software to unlock it. (we havn't found
one that works yet), or you can ask your service provider who will gladly
exchange the 10 digit code.
This is how to check the
status of the 4 different locks. Aslo don't try entering the wrong number,
because after 3 times it will block the phone for good.
There are 4 different locks
on your Nokia phone.
COUNTRY-LOCK
NETWORK-LOCK
PROVIDER-LOCK
SIMCARD-LOCK
The code to read out the
sim-lock status of your phone is
#PW+(MASTERCODE)+(Y)#
# = DOUBLE-CROSS
W = PRESS "*" THREE TIMES
P = PRESS "*" FOUR TIMES
+ = PRESS "*" TWO TIMES
MASTERCODE = 1234567890
Y = NUMBER 1 TO 4
The master code is a secret
code. The code has 10 digits, To read out the sim-lock status you can enter
every combination you want!
"Y" Shows the status of
the network-lock. Here you can enter a number from "1" to "4". The "4"
is for the sim-card lock.
SIM-LOCK CHECKS
#PW+1234567890+1# = GIVES
PROVIDER-LOCK STATUS
#PW+1234567890+2# = GIVES
NETWORK-LOCK STATUS
#PW+1234567890+3# = GIVES
COUNTRY-LOCK STATUS
#PW+1234567890+4# = GIVES
SIM-CARD-LOCK STATUS
On the main screen type in:
*#06# for checking the
IMEI (International Mobile Equipment Identity).
*#7780# reset to factory
settings.
*#67705646# This will
clear the LCD display(operator logo).
*#0000# To view software
version.
*#2820# Bluetooth device
address.
*#746025625# Sim clock
allowed status.
#pw+1234567890+1# Shows
if sim have restrictions.
*#92702689# - takes you
to a secret menu where you may find some of the information below:
1. Displays Serial Number.
2. Displays the Month
and Year of Manufacture
3. Displays (if there)
the date where the phone was purchased (MMYY)
4. Displays the date
of the last repair - if found (0000)
5. Shows life timer of
phone (time passes since last start)
*#3370# - Enhanced Full
Rate Codec (EFR) activation. Increase signal strength, better signal reception.
It also help if u want to use GPRS and the service is not responding or
too slow. Phone battery will drain faster though.
*#3370* - (EFR) deactivation.
Phone will automatically restart. Increase battery life by 30% because
phone receives less signal from network.
*#4720# - Half Rate Codec
activation.
*#4720* - Half Rate Codec
deactivation. The phone will automatically restart
If you forgot wallet
code for Nokia S60 phone, use this code reset: *#7370925538#
Note, your data in the
wallet will be erased. Phone will ask you the lock code. Default lock code
is: 12345
Press *#3925538# to delete
the contents and code of wallet.
Unlock service provider:
Insert sim, turn phone on and press vol up(arrow keys) for 3 seconds, should
say pin code. Press C,then press * message should flash, press * again
and 04*pin*pin*pin# \
*#7328748263373738# resets
security code.
Default security code
is 12345
Change closed caller
group (settings >security settings>user groups) to 00000 and ure phone
will sound the message tone when you are near a radar speed trap. Setting
it to 500 will cause your phone 2 set off security alarms at shop exits,
gr8 for practical jokes! (works with some of the Nokia phones.) Press and
hold "0" on the main screen to open wap browser.
|